Menu

TH Trash Belt Conveyor

Series Specifications

Belt

Ultimate 140 BBS – Nitrile

Drive Pulley

8″ diameter with 1-7/16″ diameter shaft at bearings, fully lagged.

Tail Pulley

4″ diameter with 1″ diameter shaft at bearings, machine crowned 13″, 19″ and 25″ BR up to 150′ long. 6″ diameter with 1-3/16″ diameter shaft at bearings, machine crowned all other applications.

Center Drive

Minimum elevation – 16-11/16″. Can be placed on any section of conveyor length. Minimum OAL without modification 12’0″. Chain guard located on left hand side.

Bed

14 ga. formed steel slider bed bolted between two 7 1/2 in. deep x 12 ga. formed steel side channels with 6 in. high guards. Standard 5, 6, 7, 8, 9, and 10 ft. long sections.

Bearings

Sealed, pre-lubricated, self-aligning, cast-iron ball bearings on drive and tail pulleys.

Snub Idler

Adjustable 2 1/8 in. dia. with HD pre-lubricated ball bearings.

Return Idler

Adjustable 1.9 in. dia. pre-lubricated bearings.

Belt Speed

65 FPM constant

Squaring Rods

3-1/2″ x 1-1/2″ x 10 gauge channel frame. Bed sections attached with couplings and floor supports.

Floor Supports

Supplied as optional equipment.

Motor Drive

1 HP–208/230/460/575V–3 Ph.–60 Hz. Premium Energy Efficient C-Face.

Capacity

Maximum load per linear foot of conveyor is 10 lbs.

Dust Pans

Solid 16 ga. underside dust covers held in place by 1/4 turn screws for easy removal.

Warning

Prevent pinch points that exist when belt conveyors are permanently attached to other conveyors! Use connector brackets with safety pop-out roller (other stationary equipment will require proper guarding and safety devices supplied by others).

Technical Drawings

TH Trash Belt Conveyor

Share on facebook
Share on twitter
Share on linkedin
Share on email